pylon:
In this case the sketch wasn't installed on the Arduino, you're still running an outdated version of it. Upload again and check for upload errors. Clear the SD card to be sure you don't get old data.
I uploaded it again, still get the same result, all values from the BME280 are not shown. This is what gets shown in the logfile:
2018/10/23 15:34:0 Temp1: -127.00 C Temp2: 18.00 C Temp3: 18.50 C Temp4: 18.00 C Hum6: 81.80 %, Temp6: 18.50 CHum7: 81.80 %, Temp7: 18.50 CLight: 14lx
2018/10/23 15:35:0 Temp1: -127.00 C Temp2: 18.50 C Temp3: 18.50 C Temp4: 18.00 C Hum6: 81.40 %, Temp6: 18.60 CHum7: 81.40 %, Temp7: 18.60 CLight: 13lx
2018/10/23 15:36:0 Temp1: -127.00 C Temp2: 18.50 C Temp3: 18.50 C Temp4: 18.00 C Hum6: 80.80 %, Temp6: 18.80 CHum7: 80.80 %, Temp7: 18.80 CLight: 14lx