Go Down

Topic: CurieIMU gets stuck in interrupt (Read 905 times) previous topic - next topic

bls8486

I am entry level into the world of programming.  I have experience in AV control systems but this is my first Arduino project.  I have an Arduino 101 and am using the Curie module for both BLE and IMU.  I am only looking at the X axis to determine vehicle motion.  If I move the board around too much, the program gets stuck in the interrupt and will not leave.  What am i doing wrong?  Is there an issue with using both BLE and IMU at the same time?  It doesn't seem like I'm asking too much from the board.

I have a lot of little things in code that I have been using to help troubleshoot the issue.

Any input would be appreciated.

bls8486

Any insight at all would be helpful.

Go Up