Go Down

Topic: Ardweeny support PWM? (Read 768 times) previous topic - next topic

ameyring

I have an Ardweeny from an old project and would like to continue using it because it so far has been a good stand-in for an Arduino. However, I'm getting strange inconsistent behavior when trying Pulse Width Modulation on the Ardweeny, which wouldn't be a problem on an Arduino. Does Ardweeny support it? If so, which pins?

Thanks.

CrossRoads

PWM comes out of the same ATMega328 pins as on the arduino:
Physical Pin 5, D3
Pin 11, D5
Pin 12, D6
Pin 15, D9
Pin 16, D10
Pin 17, D11

You have normal bootloader/sketches loaded up?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up