Go Down

Topic: Wifi only connects when connected to Arduino with serial monitor. (Read 6218 times) previous topic - next topic


Ok. I dug out a 12v 1000 mA power supply and hitched it up. It still would only connect when connected via the serial monitor.
Then I did the 3-7 pin jumper and it's connecting automagically without the serial monitor running.


Hi all. I am running into the same issue with the MKR1000. I'd like to run the arduino headless but having no luck finding any direction on the forum, as of yet. It works fine when console is open. Any jumper config for MKR1000 to make this happen?

Go Up