Go Down

Topic: MKR 1400 USB Driver (Read 353 times) previous topic - next topic

ZM1000

The installation of the USB driver failed
Device is detected as MKR 1400, but no driver found

jomoengineer

What operating system are you using?

Have you gone through the Getting Started page and installed the appropriate plug-in?
https://create.arduino.cc/getting-started/mkrgsm1400

It would be helpful if you could describe what you have done thus far to get the environment set-up.

Is there any other failure messages that you can share?

hennine

I found out were to download a driver so it works.

https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers

Go Up