Go Down

Topic: Code for tamagotchi vpet (Read 1 time) previous topic - next topic

Lifelessfire

Jun 02, 2019, 11:10 am Last Edit: Jun 02, 2019, 11:35 am by Lifelessfire
Hello,

I hope I'm doing the right thing is this forum by making a new subject.

I'm new to Arduino, I'm alot more mechanical but I have a rough understanding of code.

What I need is a code to to turn a led on, for a back light I want to install into a v-pet tamagotchi. I want to be able to hold one of the buttons on the v-pet for around 2 seconds to turn the light on and stay on.

Then to turn off the light, hold the button again for 2 seconds.

I can also pay for the help.

Any help would be really appreciated.


PaulRB

Click "report to moderator" and request that they move your post to the "Gigs & Collaborations" forum section. Also remember to modify your post and mention how much you can pay.

Lifelessfire

Just did as requested thanks.

PaulRB


patduino

Hi lifelessfire - check your PM
There are 10 types of people in the world, those who understand binary, and those that don't.

wvmarle

This is basically a combination of state change detection and "blink without delay".

Record when the button last changed to pressed state (usually low); and if 2 seconds later still in that state switch the LED on or off.
Quality of answers is related to the quality of questions. Good questions will get good answers. Useless answers are a sign of a poor question.

Go Up