Go Down

Topic: How can I connect 'Open Log' and Arduino Uno, simultaneously to a GPS module? (Read 1 time) previous topic - next topic

sarkar

Can I connect 'Open Log' datalogger from Sparkfun and Arduino Uno, simultaneously to a GPS Module like EM-406A or LS20031?

Product references:
Open Log :  http://www.sparkfun.com/products/9530
EM-406A GPS Module: [urlhttp://www.sparkfun.com/products/465][/url]
Locosys LS20031 GPS Module:http://www.sparkfun.com/products/8975

johnwasser

Looks like you could connect the RX-1 line of the logger to the same Arduino pin that is getting serial data from the GPS.  Hook up Power and Ground and set the logger to SeqLog mode and it will log everything the GPS sends.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

sarkar


Looks like you could connect the RX-1 line of the logger to the same Arduino pin that is getting serial data from the GPS.  Hook up Power and Ground and set the logger to SeqLog mode and it will log everything the GPS sends.

Hey thanks! I didn't know one can connect the rx to many pins.
It wont fry anything in the circuit , right? (sorry if you feel the question silly... please spare this newbie...)

Go Up