Go Down

Topic: Looking for help with setting up steeper motor (Read 197 times) previous topic - next topic

Hoteevi

Hello I'm totally new to Anduino and electronics itself. I'm doing a small project in which I need to set up a Stepper Motor. I ask for advice from the shop and they send me all the parts, but they didn't tell me how to connect everything. The parts I've got are:

1. Stepper motor: https://botland.com.pl/en/stepper-motors/3650-stepper-motor-jk57hs56-2804-200-stepsrot-24v-28a-126nm.html

2. Motor driver:
https://www.pololu.com/product/2974

3. Arduino Uno Rev3 - module A000066

I've got proper power supply and wiring cables. Is there any good soul who could help me with setting up everything and write a program so this motor would start to work?

TomGeorge

Hi,
Welcome to the forum.


Please read the first post in any forum entitled how to use this forum.
http://forum.arduino.cc/index.php/topic,148850.0.html


Have you googled      TB67S279FTG   arduino


This will help with connection and general layout.
What power supply do you have?


Thanks. Tom... :)
Everything runs on smoke, let the smoke out, it stops running....

bobcousins

Please ask questions in the forum so everyone can benefit. PM me for paid work.

groundFungus

The stepper is a 2.8A per coil current motor and the driver is good for 2A maximum with forced air cooling (fan) and heat sink so I would say that the driver is not the proper driver for that motor.  A better choice may be a TB660 type driver.

A couple of tutorials that may help:

Stepper basics.
Simple stepper program.
You will save everyone's time if you read and follow the forum guidelines.  https://forum.arduino.cc/index.php/topic,148850.0.html

Hoteevi

#4
Jun 16, 2019, 03:08 pm Last Edit: Jun 16, 2019, 03:09 pm by Hoteevi
Thanks so much for all your feedback!


Okey, So I'm at this stage. Pictures:

https://ibb.co/R76fPnq
https://ibb.co/rMBd5HG

And got this program from another forum page. The second one from this post. https://forum.arduino.cc/index.php?topic=277692.0

Can anyone help me and draw the lines how wires should go between Arduino and driver.

Best Regards!

TomGeorge

#5
Jun 17, 2019, 09:47 am Last Edit: Jun 17, 2019, 09:47 am by TomGeorge
Hi,

Please read the first post in any forum entitled how to use this forum.
http://forum.arduino.cc/index.php/topic,148850.0.html .

Particularly how to post pictures in your post.
Unfortunatetly some of the forum members use platforms other than PC/Laptop and unless attached or placed in a post, viewing a picture is not possible.

Thanks.. Tom. :)
Everything runs on smoke, let the smoke out, it stops running....

TomGeorge

#6
Jun 17, 2019, 09:49 am Last Edit: Jun 17, 2019, 09:51 am by TomGeorge
Hi,
OPs pics.



Please post YOUR schematic.
Tom.. :)
Everything runs on smoke, let the smoke out, it stops running....

Go Up