Go Down

Topic: Radio-controlled car (Read 125 times) previous topic - next topic

fern12

Hi guys!

Look at my new work - a radio-controlled car for my grandson.

I printed all plastic details from BS, PLA, BFlex, PetG on ANYCUBIC i3 MEGA 3D printer.

Tire wheels are made of two-component silicone. Power supply - 12.6 Volt 6800mAh battery.
Everything is controlled by the Arduino nano, the radio link is tuned through the NRF24L01 modules.
The driver for the L298n motor operates at a voltage of 22 volts. I installed 2 voltage-lowering modules, and one voltage-boosting module for the motor. LED headlights have three degrees of brightness.

The car has four transfer case operation modes: 4WD, rear-wheel drive only, front-wheel drive only, and neutral.

 The entire machine drawing is made in the SOLIDWORKS 2017 program.

What do you think? Any comments?







Power_Broker

This is really friggin cool! Can you post the stl files for others to look at/print?
"The desire that guides me in all I do is the desire to harness the forces of nature to the service of mankind."
   - Nikola Tesla

Go Up