Go Down

Topic: Micro-Mini Arduino - Sort of. (Read 1 time) previous topic - next topic

spycatcher2k

May 30, 2011, 06:05 pm Last Edit: May 30, 2011, 11:03 pm by spycatcher2k Reason: 1
Hi all, Here is my home designed controller based on the Attiny 85, Programmed with the arduino IDE. Pin headers are as follows :
6 Pin ISP
8 +5v connections (Outside row)
8 0v connections (Middle row)
Inside row is left to right - RESET | +5 | GND | D0 | D1 | D2 | D3 | D4
        (uCONTROLLER PINS : 1     |  8  | 4    |  5  |  6  |  7  |  2  | 3 )

Currently used as a controller for my robotics projects.

Available to buy if anyone interested.

Contact me via PM or via email : arduino2@badnetwork.co.uk


Drew.
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

spycatcher2k

LOL - was updating when you posted - all done.


Drew
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

FEDERICO

Federico - Sideralis
Arduino &C: http://www.sideralis.org
Foto: http://blackman.amicofigo.com

liuzengqiang

Pretty neat! Any documentations to go with it? What lib would work what would not? Frequency, SRAM, FLASH, EEPROM etc. Also cost of the entire board?
Serial LCD keypad panel,phi_prompt user interface library,SDI-12 USB Adapter

spycatcher2k

Hi - Board is £3.00 GBP - Headers, chip socket, led & resistor is about £2.00 GBP (of course you can source your own components) - Add your own Micro-controller e.g. Attiny 13, 45, 85 (the only ones I tested - 1k, 4k and 8k). Using the Core files found here : http://hlt.media.mit.edu/wiki/pmwiki.php?n=Main.ArduinoATtiny4585.
The specification for the controllers can be found here : http://www.atmel.com/dyn/products/documents.asp?category_id=163&family_id=607&subfamily_id=791

Set the fuses for internal Oscillator - 8Mhz. H-DD L-E2 E-FF No lock /bits

Drew.

Excludes P&P - Sent at Cost
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

spycatcher2k

Anyone Interested? Only got 4 left. Available as bare board or full kit (excluding uController).

PM me or email me : arduino2@badnetwork.co.uk


Drew.
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

Go Up