j'utilise un esp8266-01 et une carte mega.
je voulais tester l'exemple BangBangD1mini , et j'ai pas eu de soucis particulier lors de l'installation
BangBangD1Mini:18:1: error: 'BoardView' does not name a type
BoardView boardView;
^
C:\Users\medam\OneDrive\Documents\Arduino\libraries\BoardView-master\examples\BangBangD1Mini\BangBangD1Mini.ino: In function 'int parseRequest(char*, char*, unsigned int)':
BangBangD1Mini:66:28: error: 'matchCmd' was not declared in this scope
if(matchCmd(request,"dump")) {
^
BangBangD1Mini:69:49: error: 'addFloat' was not declared in this scope
addFloat(response, MAX_LINE_LEN, "hum", hum, 1);
^
BangBangD1Mini:72:50: error: 'addInt' was not declared in this scope
addInt (response, MAX_LINE_LEN, "relay", relay);
^
BangBangD1Mini:82:50: error: 'matchAndAssignFloat' was not declared in this scope
else if(matchAndAssignFloat(request, "hum", &hum)) strcpy(response, "ok");
^
BangBangD1Mini:85:54: error: 'matchAndAssignInt' was not declared in this scope
else if(matchAndAssignInt (request, "relay", &relay)) strcpy(response, "ok");
^
C:\Users\medam\OneDrive\Documents\Arduino\libraries\BoardView-master\examples\BangBangD1Mini\BangBangD1Mini.ino: In function 'void setup()':
BangBangD1Mini:105:2: error: 'WiFi' was not declared in this scope
WiFi.mode(WIFI_STA);
^
BangBangD1Mini:105:12: error: 'WIFI_STA' was not declared in this scope
WiFi.mode(WIFI_STA);
^
BangBangD1Mini:107:26: error: 'WL_CONNECTED' was not declared in this scope
while (WiFi.status() != WL_CONNECTED) delay(500);
^
BangBangD1Mini:120:2: error: 'boardViewParseRequest' was not declared in this scope
boardViewParseRequest=parseRequest;
^
BangBangD1Mini:121:2: error: 'boardView' was not declared in this scope
boardView.name="Bang-bang";
^
C:\Users\medam\OneDrive\Documents\Arduino\libraries\BoardView-master\examples\BangBangD1Mini\BangBangD1Mini.ino: In function 'void loop()':
BangBangD1Mini:148:2: error: 'boardView' was not declared in this scope
boardView.loop();
^
exit status 1
'BoardView' does not name a type