i attached the circuit but didn't figure out how to post it in the post.
it must be make before break scenario
i am at a loss when coming up with a program to control the two inputs to the up and down pins on the 49110be.
i will have taps coming off the inductor 46 of them that are connected to an IGBT and drivers that is connected to the above circuit or a shift register. it must be make before break scenario meaning the next in line is fully up before the last one cuts off. this is to ensure a steady current flow through the Inductor.on each end of the Inductor i have electromagnets that are varied from high to low 180 degrees out from each other, one rising, one falling at the same time. the electronics is to mimic a brush rotating in a circle that make contact with two contacts at a time which are actual loops of wire around the Inductor that changes the magnetic flux to current ratio on a steady basis.