marathonMAN1:
i will have taps coming off the inductor 46 of them that are connected to an IGBT and drivers that is connected to the above circuit or a shift register. it must be make before break scenario meaning the next in line is fully up before the last one cuts off. this is to ensure a steady current flow through the Inductor.on each end of the Inductor i have electromagnets that are varied from high to low 180 degrees out from each other, one rising, one falling at the same time. the electronics is to mimic a brush rotating in a circle that make contact with two contacts at a time which are actual loops of wire around the Inductor that changes the magnetic flux to current ratio on a steady basis.
So 46 taps on EACH inductor.
Each tap has an IGBT on it?
So you will have your inductor connected to a powersupply at the start of its winding and with IGBTs connect each tap in turn with the other end of the powersupply?
What voltage/current and how is your inductor constructed?
How many inductors?
Can you post a basic diagram of how your project will be constructed?
Thanks.. Tom.. 