Go Down

Topic: LilyPad programmer/bootloader connection issue (Read 211 times) previous topic - next topic

crunchydimples

Hi,

I am completely new to Arduino and I am wanting to create a sound-reactive LED for a wearable using a lilypad. I have attached a photo of the sound sensor I am using and the lilypad pins. The code i have used is :

#define LEDstrip 7


void setup()
{
  pinMode(7,INPUT); //SIG of the Parallax Sound Impact Sensor connected to Digital Pin 7
  pinMode(LEDstrip, OUTPUT);

}

//this function will make the LED dim once the Parallax Sound Impact Sensor sends a 1 signal, and then return to it's original brightness.
void loop()
{
  boolean soundstate = digitalRead(7);
  if (soundstate == 1) {
         analogWrite(LEDstrip, 255);
         delay(10);
  }
  else{
 
    analogWrite(LEDstrip,0);
  }
}


The error messages I get are:

avrdude: butterfly_recv(): programmer is not responding

avrdude: error: programmer did not respond to command: exit bootloader

I have tried this on board: Lilypad Arduino USB and Lilypad Arduino and port: serial 1 and 2

Again bare with my noob experience and any guidance will be greatly appreciated thankyou (:

Go Up