Go Down

Topic: Olimex LCD + UNO (Read 10597 times) previous topic - next topic

GBergman

Hej alla,

jag har inhandlat en st.UNO och en st. OLIMEX "SHIELD-LCD16x2". Jag kan köra UNO mha / USB med basala övningar , "blink" osv. Nu är det dags för LCD, men hur hittar jag bibliotek för denna och hur installeras det för att allt skall funka?

/G.

mfalkvidd

Hej G

Har du provat https://www.olimex.com/Products/Duino/_resources/Arduino_instructions.pdf ?

pert

I've deleted your other cross-post @GBergman.

Cross posting is against the rules of the forum. The reason is that duplicate posts can waste the time of the people trying to help. Someone might spend 15 minutes (or more) writing a detailed answer on this topic, without knowing that someone else already did the same in the other topic.

Repeated cross posting will result in a suspension from the forum.

In the future, please take some time to pick the forum board that best suits the topic of your question and then only post once to that forum board. This is basic forum etiquette, as explained in the sticky "How to use this forum - please read." post you will find at the top of every forum board. It contains a lot of other useful information. Please read it.

Thanks in advance for your cooperation.

Albireo1

Själv tyckte jag denna introduktion gav mig mycket .: How to control a character I2C LCD with Arduino
Men du kanske har denna display .: How to use a 16×2 character LCD with Arduino

Go Up