Go Down

Topic: Soldering wires to pin-headers - am I just heavy-handed? (Read 14352 times) previous topic - next topic

spycatcher2k

I use what I have - I'm Unemployed due to Illness at the moment (and will be for at least a year or two) & house bound - so don't have much available cash. I get the occasional repair job in, but thats it. Using up my 'BITZ' a bit to quickly, and getting stuff to strip down has been difficult - normally I would of used a bit of ribbon from an IDE cable, but none left.
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

Techone

@spycatcher2K

Good idea ! a small homemade PCB with heathers and wires. Thank for the tip. By the way, nice set-up. Me is simply wire and breadboard.

spycatcher2k

Hi all, I've got a few of these header PCBs - Anyone want a set, releasing them as 'swapware' - If you want a set - I'll send them to you FOC - all I ask is for something interesting to swap it with. I will also put up my ATTINY Micro Boards on the same offer (ATTINY 13/2545/85 based board with ICSP header and pins D0 - D4 broken out) - Also got 1 Shiftshield32 board - whats your offer!!!

These are unpopulated boards - no components - if you want components, make me an offer and I'll see what I can do.
Mrs Drew
-=-
http://www.uk-pcb.co.uk - UK PCB Fab Company
I will design & code for you, but I will also charge you (PM me)
If you don't like my answers, realize : I'm not being cheeky, I'm Just trying to prompt you to use your own brain/google etc.

Go Up