Go Down

Topic: Voltage Divider (Read 816 times) previous topic - next topic

ajaba

#15
May 10, 2020, 06:19 am Last Edit: May 10, 2020, 06:28 am by ajaba
This is what happens when you add the diodes:


raschemmel

It would appear it is half wave rectification, but don't quote me.

ajaba

Since you didn't give a frequency I used 3000 Hz
It works at that frequency.


The simulation was tested by changing the cap values and observing the output voltages for Vout_500v and
Vout_1kV.
What is the small arrow in your sketch:

 

Thanks,
Here's 200Hz


What does the arrow at C2 and C4 stand for? I am trying to re-do your sketch in LTspice and wanted to know the role of those arrows.

Thanks

raschemmel

Quote
What is the small arrow in your sketch:
Quote
What does the arrow at C2 and C4 stand for?
The are just ground nodes. They represent where the oscilloscope ground or meter ground lead would go
if you were measuring the voltage on a real circuit. (probably unnecessary for this case)

Ignore the arrows and ask yourself how you are going to put the piezos in your LTSPICE circuit ?
(good luck finding them in the component libraries)






Go Up