Go Down

Topic: can not upload to ardunio due (Read 250 times) previous topic - next topic

arashsoft

hi i can not upload to my arduino
got this error
Code: [Select]
Sketch uses 444 bytes (3%) of program storage space. Maximum is 14336 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 1015 bytes for local variables. Maximum is 1024 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xa7
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xa7
Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.






CrossRoads

Looks like you have 168 for Duemilanove board setup, but a Due (a totally different board type) for the  Com port?

Are there other options for the Port? I'd expect the Duemilanove to have an FT232 for the USB interface. the Due did not.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

arashsoft

#2
Jun 13, 2020, 05:23 pm Last Edit: Jun 13, 2020, 05:26 pm by arashsoft
i tested these port and also arduino 328 and avr isp bootloader
but got that error






all pin is empty i just want to upload an empty project

pert

As CrossRoads explained, you have the wrong board selected from the Tools > Board menu. Despite the somewhat similar names, the Due and the Duemilanove are very different boards.

Do this:
  • Tools > Board > Boards Manager
  • Wait for the downloads to finish.
  • From the list of boards platforms, select "Arduino SAM Boards (32-bits ARM Cortex-M3)"
  • Click the "Install" button.
  • Wait for installation to finish.
  • Click the "Close" button.
  • Tools > Board > Arduino Due (Programming Port)
  • Now try uploading again.

arashsoft

oh i didn't got that thanks
it works

pert

You're welcome. I'm glad to hear it's working now. Enjoy!
Per

Go Up