Go Down

Topic: GY-BNO055 Issues (Read 5879 times) previous topic - next topic

Lithimlin

Ok, I got it to work nicely with the following setup:
Well, properly reading through this actually solved problems number 1 and 3 and I think I'll be able to figure out the answer to problem 2 from here.

Sorry for the inconvenience!

VitallyRaccoon

No trouble at all! I've been working with this sensor quite a bit since my initial post. If you need any help getting it going don't hesitate to let me know!

Nemecsek69

Hi.
A programmer here, completely ignorant about hardware  :(

I bought the same board and it came without any documentation. Is there a link online, not about the chip but the board?
 
Is it possible to connect it directly to an Arduino using 3.3V for VIN and don't use any level shift?
Do I need to add +3.3V pullups (4.7K) to I2C lines? 

Sorry for the silly questions, but the theory behind is quite above my competence...

Thanks

myurtricks

I'm having bno055 with stm32 bluepill I am tried lot of times still it is not working please anybody help me to find out this issue
Thanks.

Go Up