Go Down

Topic: MKR Motor Carrier LiPo switch not lighting LED green (Read 178 times) previous topic - next topic


Hi, i'm looking for some help with this board.

I have the MKR1000 board connected to it and updated the firmware via MATLAB setup. However, I connect the two boards, the LiPo, plug it into the PC and switch it on the MKR Motor Carrier board so that it should run off the LiPo and it don't get the LED to turn on.

Any help appreciated. Iv.e checked the battery and its giving me the correct voltage so thats not the issue.


Go Up