Go Down

Topic: nrf24l01 in an RC car (Read 54 times) previous topic - next topic

strouhanka

Hi, I'm creating a 3D printed RC car and want to use NRF24L01 wifi module for communication. And I wanted to  ask, whether it would work, if a PCB with the NRF was on the chassis of the car, the hight of the car was 70mm and it was made from PLA?




Robin2

I think it should work very well. I don't think the location of the nRF24 will matter all that much as long as you ensure that the antenna is not shielded by metal.

The important issue is the distance over which you want the wireless to operate.

...R
Simple nRF24L01+ Tutorial
Two or three hours spent thinking and reading documentation solves most programming problems.

Go Up