Go Down

Topic: Can´t upload a sketch !! Pls help (Read 188 times) previous topic - next topic

pikot

Oct 18, 2020, 03:28 pm Last Edit: Oct 18, 2020, 03:29 pm by pikot
Hello i just bought my first arduino. Its an arduino uno. I tried a simple led program tutorial but i am unable to upload the program to my arduino. In tools i have selected board: Arduino UNO Port: COM 6 (the only one available)
This is my first ever sketch
I use version 1.8.13
Error message:

Arduino: 1.8.13 (Windows 10), Board: "Arduino Uno"

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x53

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x53



This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

CrossRoads

When you unplug the Uno, and then look at Ports, does COM6 drop off the list?

Are you sure you have a Data cable, and not a Power only cable?

What is the chip near the USB connector? MEGA16U2, or something else? Might need a magnifying glass to read it. 
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

pikot

COM6 drops off after disconect,
The chip closest is CH340G, this chip is the second biggedst on the arduino and has 8 silver legs on each side
I am not sure about the cable
but this is the description of what i have bought 

WAVGAT high quality One set UNO R3 (CH340G) MEGA328P for Arduino UNO R3 + USB CABLE ATMEGA328P-AU Development board

Go Up