So i got this program and it works fine. It is supposed to generate a pwm signal of a predetermined frequency by using a function. The downside however is that i can only run this function on one pin at a time. How can i get it to start and finish on 2 pins simultaneously (for example pin 10 and 11…

2 pins at the same time

system April 28, 2012, 8:46am 2

Have you looked at the blink without delay example?

Topic		Replies	Views
Writing to several pins simultaneously Programming	3	1011	May 5, 2021
2 leds off one command? Syntax & Programs	12	3328	May 6, 2021
Simultaneous Pulses w/ picture now Syntax & Programs	4	1061	May 6, 2021
Running the same function with two different pins Programming	4	1415	May 5, 2021
PWM Pin Out Deutsch	9	1955	May 6, 2021