crimson66:
When I replace my appropriate PINs and remote key codes my servos do activate and do their idle jitter, however my remote does nothing. I can run serial monitor and receive codes no problem.
Are the pins you are using different from the pins used in the code you provided above?
Are you using an Arduino UNO?
Are you saying that the Serial Monitor shows the IR codes you are using but the servo is not moving as expected?
Jitter on your servos could mean that the ground wire is not connected to Arduino Ground or maybe the power is inadequate. How are you powering the servo? The +5V line of an Arduino UNO is usually not adequate to power a servo. Allow about 1000 mA per servo.