I've been fiddling with a 20x4 i2c LCD with daughterboard GY-LCD-V1 purchased from rcmodel369. The board comes default with the pcf8574T address lines pulled low via 10K smd resistors (address 0x20). There are solder pads on the edge of the daughterboard marked A2, A1, A0 that allow you to pull the …

20x4 i2c GY-LCD-V1 daughterboard pullups insufficient ?

liuzengqiang November 3, 2012, 11:13pm 3

Care to post a link to the product page?

Topic		Replies	Views
I2C Display Troubleshooting	18	6560	May 6, 2021
DFRobot I2C LCD problems Interfacing	6	4309	May 6, 2021
Interfacing with LK202-25 LCD through I2C Interfacing	5	2278	May 6, 2021
Problem with interfacing an LCD with PCF8574N Displays	6	3333	May 6, 2021
LCD just blinks Displays	14	18853	May 6, 2021