3.2" TFT LCD Shield + Display w SD Socket for Arduino Mega 2560, SD Problem

Projects General Guidance
3

SurferTim:
What pin is the microSD card slave select pin? I think I would put it on digital pin 49.

The Mega2560 SPI data lines are:
MISO -> pin 50
MOSI -> pin 51
SCK -> pin 52

Then I would try this in setup:

if(!SD.begin(49)) Serial.println("SD fail");

else Serial.println("SD ok");

You mean like this:

#include <SD.h>

File myFile;

void setup()
{
 // Open serial communications and wait for port to open:
  Serial.begin(9600);
   while (!Serial) {
    ; // wait for serial port to connect. Needed for Leonardo only
  }


  Serial.println("Initializing SD card...");
  // On the Ethernet Shield, CS is pin 4. It's set as an output by default.
  // Note that even if it's not used as the CS pin, the hardware SS pin 
  // (10 on most Arduino boards, 53 on the Mega) must be left as an output 
  // or the SD library functions will not work. 
   pinMode(10, OUTPUT);
   pinMode(53, OUTPUT);

   //digitalWrite(53, LOW);
   //digitalWrite(10, HIGH);

   
  if(!SD.begin(49)) Serial.println("SD fail");
else Serial.println("SD ok");
  
  // open the file. note that only one file can be open at a time,
  // so you have to close this one before opening another.
  myFile = SD.open("test.txt", FILE_WRITE);
  
  // if the file opened okay, write to it:
  if (myFile) {
    Serial.print("Writing to test.txt...");
    myFile.println("testing 1, 2, 3.");
	// close the file:
    myFile.close();
    Serial.println("done.");
  } else {
    // if the file didn't open, print an error:
    Serial.println("error opening test.txt");
  }
  
  // re-open the file for reading:
  myFile = SD.open("test.txt");
  if (myFile) {
    Serial.println("test.txt:");
    
    // read from the file until there's nothing else in it:
    while (myFile.available()) {
    	Serial.write(myFile.read());
    }
    // close the file:
    myFile.close();
  } else {
  	// if the file didn't open, print an error:
    Serial.println("error opening test.txt");
  }
}

void loop()
{
	// nothing happens after setup
}

No the problem still persist...

Thanks