3d delta printer - HELP

Projects General Guidance
1

HELLO, I WANT TO MAKE A 3D PRINTER,
AND I ARDUINO UNO, EasyDriver Shield FOR STEPPER MOTORS, A TOTAL OF 4.

I want to use this software for pc Repetier-Host, and this code for arduino made by Marlin-deltabot, the problem is that no one accepts arduino, arduino only accepts RAMPS + 1.4 Mega 2560.

someone has modified to walk with arduino one, these EasyDriver Shield?
I'm not interested add a lcd, so they turn on and off the hotend that could use a relay?

for help, I do not have the funds to buy a sufientes RAMPS + 1.4 Mega 2560.

from already thank you very much.

2

Naruto128:
EasyDriver Shield FOR STEPPER MOTORS, A TOTAL OF 4.

Do you mean that you have 4 Easydriver stepper motor driver boards? If so they are not Arduino shields.

the problem is that no one accepts arduino

I don't understand - is there a translation error?

someone has modified to walk with arduino one, these EasyDriver Shield

I presume you mean "work with". But I don't understand the question. What drivers is it (whatever IT is) designed to work with?

...R

3

I want this code /Marlin, work on arduino one.

I want to work with this hardware:

  • Arduino one
  • EasyDriver easy
  • 4 Stepper Motor (NEMA 17)
  • hotend for ABS bed
  • bed pcb ned
  • No lcd
  • Use mosfet or relay, for bed and hotend?
  • no sd card

I tried to contact the author of the code, but can not find your email.

someone to help me do the above, I have sufficient funds
to buy the RAMPS + 1.4 Mega 2560

4

You have explained clearly what you want to do.

But you have not explained what you think is preventing you from doing that?

You must have some reason to expect a problem but I don't know what that is.

...R

5

Robin2:
But you have not explained what you think is preventing you from doing that?

...R

little programming knowledge.

6

Naruto128:
little programming knowledge.

I understand that. But please give me something to enable me to help you.

At the moment I don't know what to tell you because I don't know what concept of the problem you have in your head. There must be some specific reason that is preventing you from going ahead with the project.

A 3-d printer is not a beginners project unless you are building a kit. If so, what kit? - post a link.

Don't worry about questions sounding stupid. The only stupid questions are the ones you don't ask.

...R