3d printer engines do not walk properly

I'm using arduino mega 1280 ramps 1.4 fimwared repetier engines only a step in all directions but not one more. configure it from here http://www.Repetier.com/firmware/v091/ Not be that bad water

a greeting I hope your help

I think you would be more likely to get useful information on the RepRap forum.

I also think you have some translation problems. Do you mean "work" rather than "walk"?

But I have no idea what you should have in place of the word "water".

...R

But I have no idea what you should have in place of the word “water”.

Wiring perhaps?