3d Stepper Motors NOT Moving, just vibrating?

Other Hardware Motors, Mechanics, Power and CNC
1

Hello Everyone,

I am very new at 3d Printing and I am seeking more experienced help. I know your time is valuable and I am super grateful for any help I will even pay you for any help you can give to help me solve my problem.

I have built a Cartesian 3d Printer with 2 extruders, heated bed an Azteeg X3 Pro board, Viki LCD Screen, with a 12Volt 25Amp power supply.

I have connected heated bed, stepper motors, extruders, power supply all according to its correct specs and diagrams provided by manufactures.

I have uploaded Repetier Firmware and am using Repetier Host to communicate with board and after many hours and a new computer I finally configured everything correctly and it is connected without any errors...

BUT, I cannot get the stepper motors to move, they just vibrate. The heated bed works and extruders 1 and 2 do not heat.

Any ideas on what my issue might be? I am happy to send more pictures.

Have a great day and thank you in advance for hearing me out.

3686×2765 915 KB

4608×3456 986 KB

4608×3456 969 KB

3686×2765 927 KB

2

You may have connected them wrong, they may be the wrong motors?

3

Robles-Robotics:
I am happy to send more pictures.

They are nice photographs but they are useless for troubleshooting. They just give the impression of a bird's nest or a ball of spaghetti.

I think you are more likely to get useful advice on one of the Reprap forum (or similar).

This Forum is mainly about helping people to write Arduino programs.

...R