9DOF Razor IMU issue = (

Hello. Hope you all fine. I would like to use the 9DOF Razor IMU in my Arduino to measure the rotation angle of my robot. I would be grateful if somebody could help me to view its results. I did the following bust I didn’t get anything from it.

/*

Read data from the 9DOF Razor IMU board via arduino duemilanove board.

1. Upload this Sketch to the Arduino board
2. Disconnect the USB cable from the PC. 
3. Connect the jumper wires between the two boards
   according to the following table:

9DOF Razor IMU | Arduino Duemilanove
---------------|--------------------
TX0............|TX1.................
RX1............|RX0.................
3.3V...........|3V3.................
GND............|GND.................
---------------|--------------------

4. Connect again the USB Cable to the PC.
5. Open Serial Monitor.
6. Send the character '1'.
7. Send the character '0' to view the 9DOF Razor IMU Menu.

*/

void setup() {
  Serial.begin(38400);
}

void loop() {
  if(Serial.available()) {
    Serial.write(Serial.read());
  }
}

Please help me to figure out this problem

Thank You

Usually tx of one device goes to rx of the other…
tx—>rx
rx<—tx

Thanks winner10920

Actually I tried what you said but still I get nothing. I searched about it and all project are using:

tx--->tx rx--->rx

Did you change the serial monitor to 38400?