Everything works wonderfully except for one portion of the sketch. In the sketch, I am telling the arduino to set pin 7 HIGH in the case that certain conditions are met and then once those conditions are satisfied to turn it off again. this works fine for when my switch pin is reading 1 (HIGH) but …

A little trouble with my thermostat sketch.

modsbyus November 28, 2012, 3:21am 2

Forgot to say what it is doing right...LOL
in "cooling mode" its not turning on the SSRFan... sorry

Topic		Replies	Views
More Help With My Thermostat General Guidance	10	4131	May 5, 2021
Programming Question..? Programming	6	2087	May 5, 2021
1 hr. delay with outputs left on. Syntax & Programs	13	5524	May 6, 2021
Help with adding a task into my code General Guidance	4	1509	May 5, 2021
Two Pins on Low become High??? Programming	2	451	May 5, 2021