Hello all, I am trying to use the RP2040 for some real time applications, and I am running into an issue with reading the A6 pin. It is taking 18ms (far too long for my application) to read the A6 pin when the device is in 'BLE' mode (when BLE.begin() is ran). When I remove the call to BLE.begin()…

Welcome to the forum. The RP2040 does not have a lot of analog pins. Therefore the Arduino team made use of the NINA module analog pins. I suspect the pins you have issues with are on the module and you need to get trough an additional interface (hidden from the average user) to make use of the pin…

A6 Pin takes 18ms to read while in BLE Mode

Official Hardware Nano Family Nano RP2040 Connect

system Closed April 15, 2022, 7:55pm 3

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.

Topic		Replies	Views
analogRead() take 30µs, 60µs, 90µs or 120µs randomly in bare example Programming	6	614	June 24, 2021
analogRead() when using BLE Nano RP2040 Connect	5	1422	October 26, 2021
Arduino nano ble reading of the board's sensor values fails after a time Networking, Protocols, and Devices	7	1184	May 6, 2021
delay(1) in analogRead() Bugs & Suggestions	2	1930	May 6, 2021
Poll Nano with BLE for Motion Sensor State Networking, Protocols, and Devices	4	1389	May 6, 2021

A6 Pin takes 18ms to read while in BLE Mode

Related topics