Dear friends,
how to connect arduino board and AC Xinje DS5F servo motor? attached are instructions that are unclear to me. do i need an extra 24 volt power supply, and a 3.3k resistor and how do i actually connect everything.
I connected P- i D- (ac servo) with Gnd (arduino) and P+5v (ac servo) with Pulse (arduino) and D+5v (ac servo) with Dir (arduino) nothing happens ... this is normal works with hybrid and step drivers but not with this servo.
Thanks a lot
Welcome back
Please post a link to the datasheet or attach the datasheet itself. Pictures are (in general) useless.
Sorry, see it's attached; just a little small.
Your topic has been moved to a more suitable location on the forum. Installation and Troubleshooting is not for problems with (nor for advice on) your project 
See About the Installation & Troubleshooting category.
1 Like
Screenshots are often hard to read. The characters are too small and often the colour has a poor contrast. Better send link to the datasheets.
I found a way. it is necessary to connect an additional power supply of 24 v and + with +24 and - connect with SI1 and it works ok ... but now I have another problem the speed on the arduino is at maximum but the servo motor is still slow ...
on Arduino delayMicroseconds(1) is 1, the minimum I can set , byt pulse/rev on ac servo motor is 10000 because of that the engine speed is low.
how to solve this problem now?
This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.