acs712 with relays and buttons

Projects General Guidance
1

Hi everyone
I have some problems and i can not figure out where the fault is
i have a bulb connected to ACS712 to sense its amps and all of that after relay depends on push button press
when I press the pushbutton the relays turns on and so the bulb and acs712 and if the current is not less than 0.2 amps the bulb is ok and if not switch to relay2

all the time i press the pushbutton and nothing happen

2

Please read "Read this before posting a programming question" at the top of the forum.

You need to be a little lot more specific about your problem:
Sketch, schematic (not pretty Fritzing drawings), error messages, etc.