What is typically used to adapt 1mm diameter pins so they'll fit into the smaller through-hole protoboard sections like on the MKR Proto Shield? I'm sure this is slightly larger than normal, but it's coming off of a 5V/3A output switching regulator that I'd like to solder onto the MKR, so that may e…

Adapter for a 1mm component pin to fit MKR Proto Shield proto area?

Paul_KD7HB September 13, 2021, 6:06pm 2

Nothing is used. The pins are bend over after going through the hole and then soldered.
Paul

Topic		Replies	Views
name the part Troubleshooting	3	884	May 6, 2021
proto for 2560 How to get it wrong - twice Hardware Development	6	4890	May 6, 2021
Mini Pro (or so) - temporary connecting pins without soldering? General Electronics	15	12558	May 6, 2021
Spaziatura pin Generale	8	2270	May 7, 2021
Screw terminals that reliably fit in protoboards? General Electronics	10	3267	May 6, 2021