How do people normally mount their screens in an enclosure?
This is the one I am using:Lolin TFT .
I am thinking of designing a 3D printed case on Tinkercad, so my wife will allow it in the living room 
Is it just a case of measuring with caliper, and setting it so the holes line up with studs inside?
Inside the case will be:
Wemos D1 mini
1.44" TFT
DHT12 sensor (to the rear in a ventilated area, or mounted direct to rear but seems a bit messy).
THIS is one in my garage, will not be allowed in the living room though
Any tips would be helpful.