Advice on connecting Arduino Uno R3 + Esp32 Cam + 2x MG996R

[klaidon]

Hello everyone, I'm very new to arduino so if you could help me it would be very much appreciated. I basically need advice in two situations:

1- How should I power my 2 servo motors if these are the specifications
Operating voltage: 4.8 V a 7.2 V
Running Current: 500 mA - 900 mA (6V)
Stall Current: 2.5 A (6V)
The idea is not necessarily to have them running 24/7 but a somewhat sustainable way for a few minutes whenever I need it to. And are jump wires ok for the connections?

2- The second question is wether I would need a logic level shifter if I want to program the Esp32Cam with the Uno board, and receive its data to control the 2 servo motors.

[Railroader]

@klaidon

How should I power my 2 servo motors if these are the specifications
Operating voltage: 4.8 V a 7.2 V
Running Current: 500 mA - 900 mA (6V)
Stall Current: 2.5 A (6V)

Get a power supply according to those figures, capable op more then 5 Amps.

@klaidon

would need a logic level shifter

Yes.

[klaidon]

Does something like this work ?

[srnet]

@klaidon

Does something like this work ?

Plug in breadboards are definetly not good for connecting high current devices like servos.