Hello All-
I would greatly appreciate some help. I apologize for the long post, just want to explain everything. I have a 30 channel ambient lighting setup with Arduino Uno Rev3 connected to two tlc5940 on a breadboard as per instructable http://www.instructables.com/id/30-channel-LED-RGB-Ambilight-Clone/
I am using 10 led strips connected to the tlc's.
I am using hardware setup based on Google Code Archive - Long-term storage for Google Code Project Hosting.
However, I keep getting error message when opening boblight "Wrong channel value 3 for device uCon on light left_upper"
I swapped led colors, strips, and even tried another breadboard. But same message. When I upload the amblight.pde to arduino, the led strips do react, however, can't get it to work. Also when I run boblight-getpixel, it always times out.
Can someone Please please guide me on how to get this working.... I am running Windows 7 64 bit pc
My boblight config file is as follow:
[global]
interface 127.0.0.1
[device]
name uCon
output "COM7
"channels 30
type momo
interval 20000
prefix FF
rate 115200
debug on
name red
rgb FF0000
name green
rgb 00FF00
name blue
rgb 0000FF
[light]
name left_upper
color red uCon 3
color green uCon 2
color blue uCon 1
hscan 0 20
vscan 0 50
[light]
name left_lower
color red uCon 6
color green uCon 5
color blue uCon 4
hscan 0 20
vscan 50 100
[light]
name bottom_left
color red uCon 7
color green uCon 8
color blue uCon 9
hscan 0 33
vscan 80 100
[light]
name bottom_middle
color red uCon 12
color green uCon 11
color blue uCon 10
hscan 33 67
vscan 80 100
etc. etc.