I have a controller that can output 0-10DC or 4-20MA.. It also has digital outputs/inputs and analog.
This controller I can write any number from 0 to 10dc and it will output. Should I be able to run a small dc motor with this setup?
I was going to use this controller and also my arduino to do tasks..
I have a small motor i took of a car. When I connect it to a 3dc or 5dc power. Motor starts spinning.
When I output same dc out of my controller motor does nothing.
With same output from controller I was able to power up a 5dc power board. So its outputing DC but for motor not working.
Im a noob in this stuff so excuse if I get things wrong lol.
I mainly did hvac service work and now went into controls. writing Where the UNT1126 I use for work its smiliar to arduino just easier to code for me since its line programming. From pre set assemblies you have pids, ao, di, do, etc..
Thanks for all your help
Here is the controllers pdf.