Hi, I am trying to drive a motor via PWM, but when I want to turn it off using analogWrite(pin, 0), I can stil hear hum from the motor. If I measure voltage on the PWM pin (nothing attached on it i.e. only uC pin) it reads 0.104V. It makes no change if I set the pin as output or not. How to solve i…

analogWrite(pin, 0) ouputs 0.104V?

system May 16, 2012, 7:50pm 3

Pure pin, only arduino/uC, hanging in the air.

Topic		Replies	Views
How much "zero" is writeAnalog(pin,0) ???? Interfacing	6	1183	May 6, 2021
Re: When using analogWrite output only goes high 255 or low 0 -SOLVED Programming	3	2236	May 5, 2021
analogWrite(3,200) works. analogWrite(A3,220) does not Programming	9	2999	May 5, 2021
How to turn off the pin that was kick started by analogWrite ? Programming	9	8508	May 5, 2021
PWM not fully off Frequently-Asked Questions	23	13062	May 6, 2021