any chances of using these motors with my Arduino?

Hi, I have been recovering all kinds of parts i might be able to use with my arduino, and i now have these two motors from an old HP printer.

rk2-0136

and

rk2-0134

does anybody know if these are stepper motors and if so how to interface with them?

thanks

I now see that there is a chip on it:

"BA6680FS is a three-phase motor pre-driver. PWM driving system is adopted in this IC as well as incorporation of a booster to drive N-channel (upper and lower) MOS FET. Current limit, FG amplifier, FG hysteresis amplifier and charge-pump are incorporated as other functions."

http://www.datasheetcatalog.org/datasheets/320/233710_DS.pdf

"BA6680FS is a three-phase motor pre-driver. PWM driving system is adopted in this IC as well as incorporation of a booster to drive N-channel (upper and lower) MOS FET. Current limit, FG amplifier, FG hysteresis amplifier and charge-pump are incorporated as other functions."

Sounds funky! ;D

Mowcius

You can only use these motors if you are prepared to make a whole bunch of electronics to generate three phase 24V power.