Where is a tutorial that shows how to use .h files
No need just put the files .h or .pde files in the same folder as your sketch and they appear in tabs when you open the sketch.
I tried 17 last night and I have had two problems with it.
-
In the Board menu each board is reported twice and there is a tick beside each. Selecting a different board results in that being ticked plus the original choice being ticked.
-
My 4X4 RGB monome won't compile. This has been traced to the library I hacked for the TLC5940. In particular single pin port definitions (only indirectly referred to in the library) like PB6 do not appear in the core as they did in earlier versions. Is there a work round for this?