Arduino easydriver4.3

I am relatively new to arduino and easydriver.
I have: easydriver v4.3
12V 0.6A 84oz-in Unipolar Stepper Motor (double shaft)
DFRobot DFRduino ATMega1280 MEGA USB Microcontroller

I am trying to use them together and make the stepper motor turn how I want. I tried a lot of codes that i found online to make it work, but the motor is just turning haphazourdsly with no order.
I am sure that my wiring is ok because all the websites that I looked on showed me approximately the same wiring schematics. I tried all of them. It’s been 3 days, and I still can’t make it work.

Please please please help me!

Thank you.

Can you post code and any schematics/photos you have?

The datasheet of my stepper motor is here: The easydriver page with pictures and schematics/datasheets is here: So I used the black and green wires, plugged them in the sparkfun easydriver A slots, and then plugged red and blue into the B slots. HEre's one of the tutorials that I followed:

Can you take a photo of your setup?