Arduino, esp-01 and display 16x2

Projects General Guidance
5

groundFungus:
I assume that the posted code is uploaded to the Uno? The wiring of the LCD in the schematic does not match the constructor in the code.

Serial.println("Starting");

That is being sent to the ESP?

And I am concerned that there is no level shifter in the Uno TX to ESP RX line.

I changed the constructor (my bad), but still doing the same.
After i upload the code, i open the monitor and it says this

ets Jan  8 2013,rst cause:4, boot mode:(1,6)

wdt reset"