# Arduino Ethernet + STEPPER MOTOR DRIVER SHIELD (DUAL) **URL:** \ **Category:** Networking, Protocols, and Devices\ **Created:** [August 28, 2012, 9:05pm UTC](https://forum.arduino.cc/t/arduino-ethernet-stepper-motor-driver-shield-dual/118016 "2012-08-28T21:05:25Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![system](https://dub1.discourse-cdn.com/arduino/user_avatar/forum.arduino.cc/system/32/1140315_2.png) [@system](https://forum.arduino.cc/u/system)\ **Post date:** [August 28, 2012, 9:05pm UTC](https://forum.arduino.cc/t/arduino-ethernet-stepper-motor-driver-shield-dual/118016/1 "2012-08-28T21:05:25Z")
Hi I'll be needing to control a stepper motor via the internet so I got this Arduino Ethernet. I found this STEPPER MOTOR DRIVER SHIELD (DUAL) at this site [http://robotics.org.za/index.php?route=product/product&product\_id=170](http://robotics.org.za/index.php?route=product/product&product_id=170). Now the problem is Arduino Ethernet uses pin 4 for the sd.. The stepper motor driver uses pins 2,3,4,5,6,7,8,9.. They both uses pin 4.. Will it conflict with arduino ethernet?.. I don't plan on using the sd.. Is there a fix for this cuz I really need to control 2 stepper motors? Stepper driver pins: x- CHannel 2 - Step 3 - Dir 4 - MS1 5 - MS2 y- CHannel 6 - Step 7 - Dir 8 - MS3 9 - MS4 ---
**Author:** ![system](https://dub1.discourse-cdn.com/arduino/user_avatar/forum.arduino.cc/system/32/1140315_2.png) [@system](https://forum.arduino.cc/u/system)\ **Post date:** [May 6, 2021, 10:38am UTC](https://forum.arduino.cc/t/arduino-ethernet-stepper-motor-driver-shield-dual/118016/2 "2021-05-06T10:38:56Z")
Closed on May 6, 2021, 10:38am UTC