I've been following guides over powering a stepper motor to an Arduino Featherwing M0 and tested the Arduino with a DC motor. For some reasons, the stepper motor just isn't working with the example they give, anyone have any ideas to what I should check to fix this?
@redtoothm, your topic has been moved to a more suitable location on the forum. Installation and Troubleshooting is not for problems with (nor for advise on) your project See About the Installation & Troubleshooting category.
I think that seeing your code (please don't forget code tags), a schematic (a reasonable sized photo (around 300 kB) of a handdrawn one is fine) and the specifications of the stepper will help others to help you.
Aiming at running a stepper and testing (what?) using a DC motor makes no sense.
Please post a link to the data sheet for the driver board. Please post schematics and code.