Arduino Fingerprint Servo code

Hi my name is Yair and im working on a lock thats based off a fingerprint sensor. i coded this but i dont know if its correct, Can someone please proofread it? Thank you so much!

This sketch will attempt to identify a previously enrolled fingerprint.
*/

#include “FPS_GT511C3.h”
#include “SoftwareSerial.h”
#include <Servo.h>

// Hardware setup - FPS connected to:
// digital pin 4(arduino rx, fps tx)
// digital pin 5(arduino tx - 560ohm resistor fps tx - 1000ohm resistor - ground)
//this brings the 5v tx line down to about 3.2v so we dont fry our fps
Servo myservo;
FPS_GT511C3 fps(4, 5);

void setup()
{
Serial.begin(9600);
delay(100);
fps.Open();
fps.SetLED(true);
pinMode(11, OUTPUT);
pinMode(12, OUTPUT);
myservo.attach(13);
}

void loop()
{
if (fps.IsPressFinger())
{
fps.CaptureFinger(false);
int id = fps.Identify1_N();
if (id <200)
{
Serial.print("Welcome Master: ");
Serial.println(id);
digitalWrite(11, HIGH);
delay(2000);
digitalWrite(11, LOW);

}
else
{
Serial.println(“Finger not found”);
digitalWrite(12, HIGH);
delay(2000);
digitalWrite(12, LOW);
myservo.write(0);
}
}
else
{
Serial.println(“Please press finger”);
}

delay(100);
}

I left something out:

This sketch will attempt to identify a previously enrolled fingerprint.
*/

#include “FPS_GT511C3.h”
#include “SoftwareSerial.h”
#include <Servo.h>

// Hardware setup - FPS connected to:
// digital pin 4(arduino rx, fps tx)
// digital pin 5(arduino tx - 560ohm resistor fps tx - 1000ohm resistor - ground)
//this brings the 5v tx line down to about 3.2v so we dont fry our fps
Servo myservo;
FPS_GT511C3 fps(4, 5);

void setup()
{
Serial.begin(9600);
delay(100);
fps.Open();
fps.SetLED(true);
pinMode(11, OUTPUT);
pinMode(12, OUTPUT);
myservo.attach(13);
}

void loop()
{
if (fps.IsPressFinger())
{
fps.CaptureFinger(false);
int id = fps.Identify1_N();
if (id <200)
{
Serial.print("Welcome Master: ");
Serial.println(id);
myservo.write(180);
digitalWrite(11, HIGH);
delay(2000);
digitalWrite(11, LOW);

}
else
{
Serial.println(“Finger not found”);
digitalWrite(12, HIGH);
delay(2000);
digitalWrite(12, LOW);
myservo.write(0);
}
}
else
{
Serial.println(“Please press finger”);
}

delay(100);
}

if (id <200)

How many fingers do you have?