I'm having trouble getting my Arduino Fio to upload sketches. I've used an Arduino Duemilanove before, and haven't had any problems with that. I've tried uploading sketches both wirelessly using a 9V battery for power and two Xbee's (the one connected to the Fio configured for 'Fio' mode, and the one connected to the PC via USB Explorer adapter configured for 'Programmer' mode), as well as wired using an FTDI cable adapter. In both cases, I'm getting the same error:
avrdude: stk500_getsync(): not in sync: resp=0x00 avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
I'm not sure what this means, or why I'm getting it. I'm using Windows 7 64-bit and my FTDI drivers are up to date. I'm selecting Arduino Fio under Tools->Board and I'm selecting the proper serial port. When programming with a wired connection, I removed the Xbee module.
As an aside, when configuring the Xbee's, I had to set the baud rate to 57600. This means that I need to set the baud rate to 57600 for the COM port on my PC, correct? Does this baud rate cause any programming issues? I set the baud rate for the COM port on my PC to 9600 when I attempted to program the Fio with a wired connection.
Any help would be much appreciated.