Hello all,
I'm new here and would like to thank you all for reading.
I have a "simple" project - I've tried doing it myself by I'm very new to it all. I'm hoping I can get some help with a small project - I'm definitely willing to pay for your help.
The project:
Arduino
- Creating a an Arduino Sketch that reads an I2C 6DOF sensor - Acceleration and Gyro and sends data to serial
LabView
- Creating a graph that displays the acceleration amount
- Creating a bar+gauge that displays the acceleration amount
- Creating a graph+gauge that reads the Gyro directions
Hardware I am using:
- SparkFun 6 Degrees of Freedom IMU Digital Combo Board - ITG3200/ADXL345 - SEN-10121 - SparkFun Electronics?
- Pro Micro - 3.3V/8MHz - DEV-12587 - SparkFun Electronics
What would you charge for this project?