Arduino Mega 2560 + 2.8inch TFTTouch shield Waveshare

Other Hardware Displays
1

Hello Everyone,

I would ask about help with first turning on my set:

  1. Arduino Mega 2560
  2. 2.8inch TFT Touch shield Waveshare

My knowledge of arduino programming is very limited, so I am asking for help with the first start of the touch screen.
I would need information:

  1. which pins to plug in where
  2. A small program that will allow me to check if the screen is working at all
  3. Libraries I need to use.

I've tried a million ways and I can't get it to work, I've read a lot of the forum and I haven't found a solution. If anyone decides to help, I will be very grateful.

all the best,
Budzilla

2

In the product page there's a link for instruction.

The instructions should be very similar to Arduino Mega.

3

The Introductory Tutorials section is for tutorials that you write, not for questions. Hence your topic has been moved.

4

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.